1992 MORBARK 1200

Machine runs and operates well.

Mill completely rebuilt by a Morbark dealer. The old mill and remaining parts are included.

Grapple has two lift cylinders; the grapple squeeze cylinder was rebuilt but still leaks slightly. Turbos were replaced at the same time as the mill — total of maybe 200 hours on all of it. The drive shaft for the mill was also rebuilt.

Elevator lift cylinders work but leak. The front outrigger (used to detach the machine from the tractor) also leaks but operates correctly. The cab heater turns on but makes noise.

Side glass panels are broken but still in place due to damage from flying debris. Most of the electronics in the control panel and display screen do not appear to work, but this does not affect the operation of the machine.

New bearings and rubber installed on all four horizontal centering wheels for the tub. The elevator belt has tears with hinges holding it together; it still works but will need replacement eventually. A few extra screens are included.